ENLIGHT REDUNDANT 300 WATT HOT-SWAPPABLE, FULL SIZE POWER SUPPLY
| Model | EN-8309961, OEM |
| Description | 300W Redundant Hot-Swappable, Full Size Power Supply |
| Input Voltage | 115V-8A, Up to 230V-4A, 50-60Hz |
| Output Voltage | 300W, Max |
| Physical Measurement | 8.75"H x 6.5"W x 7.375"D |
| Redundant Module Size | PS2 Sized Module, 2 modules |
| Temperature Range | 0OC-40OC |
| Transient Response | Output voltage returns less than 1ms |
| EMI Noise Filter | FCC Class B, CISPR22 Class B |
| Redundancy | Balanced, Shared Load |
| Compatibility | Mother Board: ATX Pentium III, Pentium IV Case: Server case ENLIGHT 8902/ 8910 |
| Safety | Each power unit meets UL, CSA, FCC and TUV IEC Specification |
 |
|
 |
| F E A T U R E S |
| Redundancy | Offer redundant function for power system and mutually backs up the outputs. A zero transfer time when backup place. |
| Hot-Swap Function | The
power system provides a Hot-Swap function. This means when either one
of the redundant power supplies fail or breaks down, you can easily
replace failed unit without any interface to the system. |
| Buzzer | A
warning buzzer sounds when any one of the power supplies fails. The
warning buzzer is resettable from either the front control panel or the
switch on the rear side. |
| Power Defective Signal | The unit provides a power defective signal thru the power monitor card (PMC-21 / 22) to acknowledge the system. |
| LED's | The
warning LED's can be found either on the rear side or the control panel
of the power system. Tells if one of the two power supplies has failed,
by LED flashing or blinking. |
| Hot-Pluggable Function | The
power system provides a Hot-Pluggable function. This method allows the
power units in the Disk Array / File Server to be removed or inserted
very easily without opening and closing the chassis. |
|
|
